clamping of throttle cable
in 912 / 914 Technical Questions
one hour ago
The 912ULS IM section 73-00-00 page 20 specifies that the throttle cable fastening bolt 241847 should be torqued to 4NM. I am using a 1.6mm multistrand steel cable threaded through the hole under the bolt head, and pressed between it and graduated sleeve 847740. I note cable is pinched quite severely under these conditions, with noticeable damage to a number of strands within the cable, particularly the inner strands. What does the Rotax community advise?
11188_1_thumbnail_IMG_9762.jpg (You do not have access to download this file.)
11188_1_thumbnail_IMG_9763.jpg (You do not have access to download this file.)
