How to bleed the oil system with a thermostat

by Juergen Buschmann in 912 / 914 Technical Questions 12 years ago

Hi,

I just changed all oil hoses and took the opertunity to fit an oil thermostat in the oil lines.
As the thermostat shortens the oil cooler under 80Â°C oil themperature I do not know how to bleed the system now.
Any ideas?

Re: How to bleed the oil system with a thermostat

by Roger Lee » 12 years ago

Roger Lee

125 5.12k 4.52k

Purge the system just like it says in the book. Check the tappets after the purge for softness, they should be firm. Follow this from the video here on our website. The oil thermostat has a small hole bypass. If you want it to purge better then apply a heat gun to the thermostat and get it hot and it will open then purge a little more. If you turn the prop over during the purge with a little speed you should see an oil pressure on your panel.

Roger Lee
LSRM-A & Rotax Instructor & Rotax IRC
Tucson, AZ Ryan Airfield (KRYN)
520-349-7056 Cell

Thank you said by: Juergen Buschmann

Report
Re: How to bleed the oil system with a thermostat

by Juergen Buschmann » 12 years ago

Juergen Buschmann

3 4 0

:cheer: Very helpful, thank you!

Juergen

Report

You do not have permissions to reply to this topic.

Title	Category	Replies
replacing coil HT wire	912 / 914 Technical Questions	1
Ring mount, rad, oil cooler, rectifier	Parts	1
914 Oil Seepage From Airbox Intake Tube	912 / 914 Technical Questions	8
New vs Old - Oil Pressure Sender	912 / 914 Technical Questions	1
OIL TEMP RISE AT MCP	915iS Technical Questions	0

How to bleed the oil system with a thermostat

Recent Videos

Safety First!

ROTALK News

Prize Giveaway!

Log In/Out

Login