Login

912 circlips

by Ed Midgley in 912 / 914 Technical Questions 4 years ago

Has anyone found an alternate way to install the piston pin circlips without the Rotax tool?

Ed

Page 1 of 2

Start
Prev
1
2
Next
End

Re: 912 circlips

by Tyler Hathaway » 4 years ago

Tyler Hathaway

3 478 1.39k

I wouldn't even try that. That tool, though expensive, is the only way to go, it seems to me.

Report
Re: 912 circlips

by Sam Purpura » 4 years ago

Sam Purpura

11 223 1.24k

It can be done with good needle nose pliers.

Report
Re: 912 circlips

by Roger Lee » 4 years ago

Roger Lee

133 5.42k 5.6k

I've been using small needle nose pliers for 20 years and never an issue.

Roger Lee
LSRM-A & Rotax Instructor & Rotax IRC
Tucson, AZ Ryan Airfield (KRYN)
520-349-7056 Cell

Report
Re: 912 circlips

by Ed Midgley » 4 years ago

Ed Midgley

4 35 77

Thanks Guys

Report
Re: 912 circlips

by RUSSELL A DUFFY » 3 years ago

RUSSELL A DUFFY

23 112 232

You guys are clearly better with needle nose pliers than I am. I need to install 4 of these, and couldn't get close to getting 1 installed today. Is there some trick to it that I don't see? I'd love to be able to do this without damaging anything, but right now I'm looking to rent the official tool.

Thanks,

Rusty

Report

Page 1 of 2

Start
Prev
1
2
Next
End

You do not have permissions to reply to this topic.

Related Topics

Title	Category	Replies
Rotax 912i Lane A /B light	912 / 914 Technical Questions	3
SL-912-I-001R1	General Tech Discussion	1
912 ULS will not run on Lane B	912 / 914 Technical Questions	2
Very high amps draw indication on Dynon D120 and 912ULS	912 / 914 Technical Questions	6
New 912 Install: Coolant sys gripes	912 / 914 Technical Questions	3

Top

© Rotax-Owner.com

Login