Ignition Coil Wire removal

The wires on the coil are on a threaded prong, it will take up to 5 or 6 turns to release.  When you go to reinstall be sure to cutback the wire about 2 or 3 mm to get a clean connection.  Put some lithium grease on the wire before you install.  

Cheers

Keep turning. The coil has a screw that goes into the core of the wire. You will need to replace the wire with a new one afterwards. 

Thank you for the fast answers. Tracking down a Lane A fault that persists. Lucky I bought the dongle so it could tell me it's an engine problem. I'll quit checking out the tailwheel now.

Bob

Since you have it, why not post the fault codes from BUDS.  

Here are the codes. Still haven't solved it. Everything i checked, sensors, plugs, wires, Injectors, all seem fine.