Trying to get the wires out of the ignition coil and can't seem to do it. I can only turn the wire about a turn and it doesn't release. Is there a special way to get it out? Didn't want to pull too hard.
Thanks.
Bob
Re: Ignition Coil Wire removal
by Rotax Wizard » 45 minutes ago
The wires on the coil are on a threaded prong, it will take up to 5 or 6 turns to release. When you go to reinstall be sure to cutback the wire about 2 or 3 mm to get a clean connection. Put some lithium grease on the wire before you install.
Cheers
Re: Ignition Coil Wire removal
by Scott Silverman » 42 minutes ago
Keep turning. The coil has a screw that goes into the core of the wire. You will need to replace the wire with a new one afterwards.
|
To receive critical-to-safety information on your ROTAX Engine, please subscribe to |
This website uses cookies to manage authentication, navigation, and other functions. By using our website, you agree that we can place these types of cookies on your device.
You have declined cookies. This decision can be reversed.
You have allowed cookies to be placed on your computer. This decision can be reversed.
This website uses cookies to manage authentication, navigation, and other functions. By using our website, you agree that we can place these types of cookies on your device.
