fbpx

 

Dear:
Yestarday I had put out my Magnetic Plug from Gearbox and I have found a metalic part with 4mm long.








My engine have 145 hours and update (912iS to 912iS Sport) the gearbox with 80 hours.
I´m very worry about it.
I get out the oil filter and I have not metalic parts inside.

Please any suggetions.

Regards
IMG-20150511-WA0000.jpg (You do not have access to download this file.)
IMG-20150511-WA0001.jpg (You do not have access to download this file.)
IMG-20150511-WA0002.jpg (You do not have access to download this file.)
IMG-20150511-WA0003.jpg (You do not have access to download this file.)
  • Re: Gearbox 912IS update to IS Sport

    by » 6 years ago


    can you take a close up photo?

  • Re: Gearbox 912IS update to IS Sport

    by » 6 years ago


    Hi AFRANIO,

    Pretty good size piece of metal. Maybe if you give Rob his close up he can figure it out. Looks like you may be pulling the gearbox and looking inside.

    Roger Lee
    LSRM-A & Rotax Instructor & Rotax IRC
    Tucson, AZ Ryan Airfield (KRYN)
    520-349-7056 Cell


  • Re: Gearbox 912IS update to IS Sport

    by » 6 years ago


    I used a pair of binoculars and had a little better look at the object. Maybe it is a piece of the phenolic thrust washer? sometimes they get caught on the splines when you reassemble the gearbox. The sport upgrade includes installing a new clutch so this is a likely explanation.

  • Re: Gearbox 912IS update to IS Sport

    by » 6 years ago


    Hi
    I have get out the gearbox and I have faults in gear of propeler shaft.











    A lot of erosion in this gear and in Dog Hub
    Rotax dealer change me the cluth to update to Rotax 912iS Sport.
    I´m very worry about it and I don´t know 912iS Reliability.

    Thanks

    Afranio
    DSCN1945.JPG (You do not have access to download this file.)
    DSCN1944.JPG (You do not have access to download this file.)
    DSCN1943.JPG (You do not have access to download this file.)
    DSCN1942.JPG (You do not have access to download this file.)
    DSCN1941.JPG (You do not have access to download this file.)
    DSCN1940.JPG (You do not have access to download this file.)

  • Re: Gearbox 912IS update to IS Sport

    by » 6 years ago


    I have seen a number of these types of chips on gear sets over the years, but they have been considered to be as a result of a prop strike.
    I have also had shafts chipping on the spline just above the ring halves.

    Looks like it will be a new gear set required. I hope you get it resolved soon.

You do not have permissions to reply to this topic.