Solder, Crimp or Both?

by geoffrey klestadt in 912iS Technical Questions 7 years ago

I'm close to wiring the engine control switches - Lane A, B, fuel pumps etc. I have PIDG crimp terminals for them. What do people prefer for reliability? Crimp, solder or both?

Re: Solder, Crimp or Both?

by Bill Hertzel » 7 years ago

Bill Hertzel

13 1.95k 7.96k

Crimp is fine, adding solder is Belts and Suspenders.

Have you looked at Positive Lock Connectors?
You can purchase 100 of them, including the housings, for under $25.

They cannot be pulled off accidentally no matter how hard you try!
Now you know what that hole is for in all those tabs!

Bill Hertzel
Rotax 912is
North Ridgeville, OH, USA
Clicking the "Thank You" is Always Appreciated by Everyone.

Report
Re: Solder, Crimp or Both?

by Rob Seaton » 7 years ago

Rob Seaton

3 1.32k 240

Solder is not a good practice for small gauge aviation use.
Among other problems it can travel down the wire strands, making it brittle.

Report

You do not have permissions to reply to this topic.

Title	Category	Replies
Crimped Exhaust Bend	912 / 914 Technical Questions	0
crimp tools	912 / 914 Technical Questions	2
Ignition Module Connector Crimp	912 / 914 Technical Questions	4
Mac crimper for engine module wires/pin	912 / 914 Technical Questions	1

Solder, Crimp or Both?

Recent Videos

Safety First!

ROTALK News

Prize Giveaway!

Log In/Out

Login