fbpx

 

I have recently purchase a new to me 2012 Tecnam P2008.  I will probably have more questions for the group later, but now I'm concerned about possible high voltage output.  In cruise, my Dynon Skyview tells me that I'm in the yellow range at 13.6 volts.  I have nothing else to turn on but the pitot heat and when I do turn it on, it does go down to 13.5 and the yellow warning goes off. Is 13.6 high or could the Dynon parameters be set a little low?  During prebuy, my mechanic noticed discoloration of the wires on the Lane B regulator and the seller replaced it.  Could the high voltage be damaging the regulator? Any advice would be greatly appreciated.  

Randy

You do not have permissions to reply to this topic.