fbpx

 

I measured the fitting coming out of the expansion tank -> the coolant overflow as 8.6mm, which would fit a 5/16"id hose fine (and does snugly, but not tightly)  but I seem to remember reading that line should be 1/4" id. Ain't no way I'm getting a 1/4"id line on that fitting unless it's with a heat gun, gallons of lube and a lot of force, which just don't seem smart. 

I was taught hoses fit connectors properly when they can't be pulled off, they have to be cut off. Since there's no room to get a clamp on there I'm a bit concerned and thought I'd get the collective's knowledge. 

 

 

Thoughts? TIA

You do not have permissions to reply to this topic.