Oil Pressure lamp on after oil change

by Brian Wilson in 912 / 914 Technical Questions 7 years ago

Hi all, I am new to the DIY oil change world. I have a 912ULS & I completed "my" first oil change today. On start up the OP registered fine at 5 bar (top o the green). Unfortunately the Oil pressure light stays on despite 3 starts/ 1 min runs. Bit stumped, good pressure on the gauge, but warning lamp won't go out. All guidance appreciated! Cheers, Brian

Re: Oil Pressure lamp on after oil change

by Roger Lee » 7 years ago

Roger Lee

126 5.13k 4.56k

Hi Brian,

My first thought is the wire connection on the sender, check oil level and depending on how you did the oil change a lot of air in the system? Did you follow the Rotax oil change procedures?

Roger Lee
LSRM-A & Rotax Instructor & Rotax IRC
Tucson, AZ Ryan Airfield (KRYN)
520-349-7056 Cell

Report

You do not have permissions to reply to this topic.

Related Topics

Title	Category	Replies
Leading edge airfoils is sold	General Tech Discussion	6
Oil Pressure Relief Valve	912 / 914 Technical Questions	9
How to Remove Outlet Line from Turbo Oil Sump	912 / 914 Technical Questions	2
Blended 100LL/Unleaded Fuel & Oil Change Interval	912iS Technical Questions	2
Fuel pressure rise	912iS Technical Questions	7

Oil Pressure lamp on after oil change

Recent Videos

Safety First!

ROTALK News

Prize Giveaway!

Log In/Out

Login