Login

hard start

by Tj Sch in General Tech Discussion 8 years ago

Page 3 of 3

Start
Prev
1
2
3
Next
End

Re: hard start

by Tj Sch » 8 years ago

Tj Sch

7 13 0

intermittent is the strange part. Went last night to try again, started without issue, it started with one mag off, both.
I will be biting the bullet and install new modules.

Report
Re: hard start

by Roger Lee » 8 years ago

Roger Lee

125 5.12k 4.53k

What are your OAT's where you live and when you tried to start. Make sure this is the modules and not just a wire that goes into one of the 6 pin connections.

Roger Lee
LSRM-A & Rotax Instructor & Rotax IRC
Tucson, AZ Ryan Airfield (KRYN)
520-349-7056 Cell

Report
Re: hard start

by Tj Sch » 8 years ago

Tj Sch

7 13 0

The temperatures here are now 50-70 degrees. I have looked over every wire i could find and found nothing unusual. I ordered and installed new modules and haven't had any issues since. I am considering sending the modules to Rotech to be tested, just to be sure.
Tim

Report
Re: hard start

by Rob Seaton » 8 years ago

Rob Seaton

3 1.32k 240

Send them!

Report

Page 3 of 3

Start
Prev
1
2
3
Next
End

You do not have permissions to reply to this topic.

Related Topics

Title	Category	Replies
engine starting	General Tech Discussion	6
Rough Starts	912 / 914 Technical Questions	7
915is generator start sequencing AND Battery chargeissues	915iS Technical Questions	4
Seems hard to navigate these pages ???	General Tech Discussion	1
912iS EM Battery vs Start Power Switch	912iS Technical Questions	2

Top

© Rotax-Owner.com

Login