914 Fuel Flow Sensor
in 912 / 914 Technical Questions
5 years ago
Hi,
My build manual (Sling 4) specifies to cut a section out of the tube leading to the right carburetor, silver solder on two 5-barb fittings and use rubber hose to insert a fuel flow sensor. Do people think that's a good way to do it? A better, easier way? Haven't done silver soldering and don't have the equipment or materials to do that.
Also, do people wrap those tubes leading to the carbs? I think my manual shows them wrapped in fire sleeve. Best way to do it?
Thanks!,
Craig
My build manual (Sling 4) specifies to cut a section out of the tube leading to the right carburetor, silver solder on two 5-barb fittings and use rubber hose to insert a fuel flow sensor. Do people think that's a good way to do it? A better, easier way? Haven't done silver soldering and don't have the equipment or materials to do that.
Also, do people wrap those tubes leading to the carbs? I think my manual shows them wrapped in fire sleeve. Best way to do it?
Thanks!,
Craig
